Hood Insulation Kits

*MADE IN USA*

Why Upgrade Your Hood Insulation?

If you don't have hood insulation or the existing hood liner is old/worn out, your vehicle will benefit from upgraded underhood insulation. Our hood kits include one of our two most popular hood insulation materials and the option to combine them with a vibration damper for additional sound and heat control.

• Hood insulation protects your hood's paint while allowing the vehicle to gets better gas mileage and cool down quicker in hot weather.
• An absorptive hood liner also will muffle engine noise.
• When combining our hood insulation materials with Damplifier Pro or Spectrum, noise inside the vehicle cabin is reduced by 3-5 dB! (20-30% less perceived noise)

How to Build Your Hood Kit 

1. Choose Your Insulation: Heat Wave Pro is recycled jute. Mega Block is hydrophobic melamine foam. Both insulators have a foil heat shield.
2. Choose Your Vibration Damper: Damplifier Pro is a peel and stick mat that is rolled on with a Wooden Hand Roller (included). Spectrum liquid deadener can be brushed or sprayed on.

Hood Insulation Kit Options

All kits with Heat Wave Pro include High Temp Spray Adhesive, Foil Insulation Tape, and Fury Folding Utility Knife.

All kits with Mega Block include Foil Insulation Tape and Fury Folding Utility Knife. No spray adhesive, because Mega Block has a peel and stick backing.

Hood Insulation Kit Installation 

Kit Combination: Damplifier Pro + Heat Wave Pro

Step 1 - Clean the metal with denatured alcohol.

Step 2 - Test fit and cut the Damplifier Pro. Install the vibration damping sheets by pushing the product on and then rolling it tight with the included wooden roller.

Step 3 - Test fit your Heat Wave Pro heat shield and cut to fit with scissors. Once fitted, an extra set of hands are helpful to hold the sheet while installing. Spray both Heat Wave Pro and the installed Damplifier Pro with spray adhesive. Wait 90-120 seconds for glue to tack. Push the Heat Wave Pro onto the hood on top of the installed Damplifier Pro, starting from the middle push towards the outer edges. Hold in place until glue has fully bonded. Tape the edges and seams of the hood's upgraded thermal insulation with the included foil tape. If your previous hood liner was held with physical fasteners, we recommend using those same fasteners on the Heat Wave Pro hood insulation.